The proposed project encompasses two areas TTI sees as being key to the path towards cost competitive wave energy – impermeable fabrics to provide compliant and thus load shedding/peak load resistant buoyant modules and fibre rope ‘load nets’ to encapsulate the buoyant modules, applying distributed restraint loads and agglomerating the distributed load back to a single or number of structural points to connect to the other parts of the WEC system such as the PTO. The load net is seen as essential in enabling the use of fabric buoyant modules as they cannot easily be restrained otherwise – the restraint must be distributed over the surface of the buoyant module. An image of the proposed concept design is shown in the 1 page slide attachment ‘NetBuoy_23_Project_Presentation’.

This combination of elements to provide the prime mover of a WEC means the overall structural mass is significantly reduced when compared to a steel structure by two mechanisms. Firstly the typical density of the materials are around one-seventh that of steel. Secondly, the materials are much more compliant with strain at break typically being achievable between 2% for the stiffest materials (e.g. high modulus Dyneema) to 20% (e.g. nylon) and upwards into hundreds of percent for elastomers and rubbers. This is all compared to steels with elastic limit typically set to 0.2%. This compliance is inherently ‘load-shedding’ as the structure is then compliant to peak loads and much less material is required to survive peak loads as steel structures are essentially strain limited (keep deflections at peak load below 0.2% elastic limit) which requires more material to provide the stiffness. Without needing the stiffness to maintain very low strains much less material can be used with synthetic structures.

The final report is now available in the Library. Note non-members will have to register.